In the process of production of cement slope protection brick mould, it is necessary t 河塘护坡模具o oil the corresponding parts of the mould. Clean up the small hole waste channel of trimming and punching die regularly. After production, the maintenance and production should be completed to carry out a comprehensive inspection of the die. The plastic mould is cleaned completely to ensure the cleanliness of the mould. Clean up the waste in the plastic mould to ensure that there is no waste in the waste box. In daily production, it is necessary to form a good habit of timely maintenance of plastic moulds in order to use them longer. 河塘护坡模具
When using slope protection brick mould to produce products, we need to clean it regularly, otherwise the products produced will appear a series of unqualified phenomena such as rough surface, which shows the importance of regular cleaning of plastic slope protection brick mould. Every interval, the mould must be completely decomposed, and then all products cleaned; in the process of regular maintenance, the outer surface of the mould should be thoroughly 河塘护坡模具cleaned, and the parts should be removed and replaced; the upper 河塘护坡模具and lower surface of the mould should be cleaned before assembly, so as to ensure that the installation surface of the mould and the working table of the press are not crushed and that the mould is installed up and down in production. Parallelism of planes, etc.